Crown DCi 4|1250DA Dante-enabled amplifier with DSP, network control/monitoring

Crown DCi 4|1250DA Dante-enabled amplifier with DSP, network control/monitoring, GPIO, 2/4/8Ω and 70/100V operation. 4 channels, 1250W/ch

The Crown DCi 4|1250DA is one of the Crown DriveCore Install DA Series. It is a Four-channel, 1250W @ 4Ω Power Amplifier with Dante™ / AES67 Networked Audio, and 70V/100V. For applications requiring Dante or AES67 networked audio it is the perfect unit to use. It is designed for providing a balance combination of channel count, output power and speaker load flexibility that works alongside with proprietary DriveCore® technology for maximum efficiency and admirable audio quality. The DCi DA Series comes with network control/monitoring, a high-powered DSP with JBL speaker tunings and the ability to drive 70V and 100V, 2/4/8/16 ohm speaker loads. The Crown DCi 4|1250DA amplifier is perfect for installations, that have standardized on Dante for networked audio transport, because of its advanced capabilities and support for Dante Domain Manager.

Features

INTEGRATED DANTE™ / AES67 NETWORKED AUDIO – Simplifies installation by enabling Dante / AES67 networked audio signals to be sent directly to the amplifier. Provides flexibility of installation options available with our expansive line-up of DriveCore Install amplifiers.

NETWORK CONFIGURATION, MONITORING & CONTROL – Better monitoring, control and audio manipulation with the HiQnet™ protocol over standard TCP/IP network. The HiQnet Audio Architect software allows for remote configuration, monitoring, and control of all aspects of the DCi-DA Series amplifiers.

PROGRAMMABLE GENERAL PURPOSE INPUT/OUTPUT PORT – GPIO ports can be configured in many different ways, such as volume controls, recall presets, or to report errors to third-party control system.

DIGITAL SIGNAL PROCESSING – DSP capabilities include the following:
LevelMAX Limiters
Input/Output EQ
Crossover
Delay
Matrix Router
Speaker Line Monitoring

- Redundant, independent Dante / AES67 ports

• Primary & Secondary
• Will accept 48khz or 96khz
• Capable of sending out Dante / AES67 audio from analog inputs pre/post processing (@ 48kHz)

- Audio Architect Control and Monitoring

- DriveCore Amplifier Technology

- Universal PFC Power Supply

- DSP

• 48kHz processing
• 20 Presets
• Input router

- High, medium, and low priority inputs

• Input delay up to 2s
• Input EQ
• Crossover
• Output EQ
• Output Delay up to 100ms
• LevelMAX limiter
• Load Monitoring

- Pilot tone

• Normal
• Burst

- Continuous Load Monitoring

- Sweep Load Monitoring

• Sleep contact closure
• Amp Status output

- Removable air filters

- Front panel LED indicators

- AES67 Compatible

- Sweep Load Monitoring

• Channel Auto-Standby
• Speaker Tunings

- Aux-Port

• Sleep contact closure
• Amp Status output

- Removable air filters

- Front panel LED indicators

- AES67 Compatible