KORG ARPMODULE1 ODYSSEY MODULE RV1 WHITE

Vendor: KORG
Description KORG ARPMODULE1 ODYSSEY MODULE RV1 WHITE The white ARP Odyssey Module made by Korg is the professionally designed re-creation of the classic analog synthesizer minus the keys. The synthesizer was originally produced in the 1970s and...
$649.99 $950.00
Title

KORG ARPMODULE1 ODYSSEY MODULE RV1 WHITE

The white ARP Odyssey Module made by Korg is the professionally designed re-creation of the classic analog synthesizer minus the keys. The synthesizer was originally produced in the 1970s and highly regarded for its sharp penetrating sound and rich range of tonal variations. This module is professionally designed featuring the original circuitry along with some updated features including MIDI and USB.

The synth module is built capable of offering a monophonic or duophonic operation. The oscillator section comes including two VCOs with sawtooth, square, and pulse waveforms. Additionally, all three revisions of the filter are immediately accessible with the use of a switch and further broaden the tonal palette. Type I (rev. 1) is a 12 dB/Oct circuit, while Type II and III (Rev. 2 & 3) are 24 dB/Oct, and each type that is adding distinct flavors and colors to the sound. Both of the portamento circuits (Rev.1 & 2/3) are available as well, and a drive circuit has been added to the VCA at the same time, producing distortion and generating a rough and raw sound. All of the sliders have been updated and are smoother than the original, that makes the synth uncompromisingly playable.

A variety of functions and modulation possibilities are made provided by oscillator sync, sample & hold, pulse-width modulation, a high-pass filter, an LFO, two types of envelope generators, and pitch bend with the use of the proportional pitch controls (PPC). The ARP Odyssey ships along with a power adapter, a 1/4" cable, and an 1/8" cable.

  • Monophonic or duophonic operation
  • 2x VCOs featuring Sawtooth, Square, and Pulse waveforms
  • VCF switchable between rev. I, II, and III
  • VCA with overdrive
  • ADSR envelope generator
  • AR envelope generator
  • LFO
  • Noise generator
  • Portamento
  • Ring modulator
  • Sample & hold
  • External audio input
  • USB MIDI
  • CV/Gate I/O
  • Extended body protects keys
  • Phone and mini-phone cables included

ARP · 1 Neuromancer

 

Polyphony Maximum Polyphony: 2 voices for duophonic; normally monophonic
Controllers Transpose Positions: 2 octaves down, normal, 2 octaves up
Proportional Pitch Control
Pitch Down Pad (b): about -2 / 3 octave
Modulation Pad (-)
Pitch Up Pad (#): about +2 / 3 octave
Noise Generator Noise Spectrum Types: White and pink
Portamento Maximum Speed: About 0.01 ms/oct
Minimum Speed: About 1.5 seconds/oct
VCO Voltage-Controlled Oscillator
Waveforms: Sawtooth, square, pulse (dynamic pulse)
Frequency Range:
VCO-1 in Low-Frequency Mode: 0.2 to 20 Hz
VCO-1 and VCO-2 (Audio Range): About 20 Hz to 20 kHz
Warm Up Drift: 1/30 semitone from turn on max
Pulse Width: 50 to 5%
Pulse Width Modulation:
ADSR: +45%
LFO: +15%
Voltage Controlled Response: 1 V/oct
Maximum Frequency Shifts:
LFO Sine Wave: +1/2 oct.
LFO Square Wave: +1.5 oct.
ADSR: +9 oct.
S/H: +2 oct.
(*VCO-1 is low-note priority, VCO-2 is high-note priority)
VCF Voltage Controlled Filter
Types: Low pass (I: 12 dB/oct., II III: 24 dB/oct.)
Frequency Range: 16 Hz to 16 kHz
Maximum Usable Q: 30
Resonance: 1/2 - self oscillate
Voltage Controlled Response:
C3 key (left edge) 0 V
C6 key (right edge) 3 V
VCA Voltage Controlled Amplifier
Dynamic Range: 80 dB
Ring Modulator Type: Digital
Input Signal: VCO-1, VCO-2 (square wave)
Sample & Hold Command Sources: Keyboard or LFO trigger
Sampled Signals:
VCO-1 sawtooth wave and square wave
VCO-2 square wave and pink noise
Envelope Generators ADSR Envelope Generator
Attack Time: 5 msec. to 5 sec.
Decay Time: 10 msec. to 8 sec.
Sustain Level: 0 to 100% or Peak
Release Time: 15 ms to 10 seconds
AR Envelope Generator
Attack Time: 5 ms to 5 seconds
Release Time: 10 ms to 8 seconds
Control Input Control Input Jacks
Pedal: 1/4" / 6.3 mm monaural phone jack
Portamento Foot Switch: 1/4" / 6.3 mm monaural phone jack
Audio Output Low
Connector: 1/4" / 6.3 mm monaural phone jack
Maximum Output Level: -20 dBu @ 10 kOhms load
Output Impedance: 10 kOhms
High
Connector: XLR connector
Maximum Output Level: +4 dBu @ 1 kOhm load
Output Impedance: 330 Ohms
Headphones
Connector: 1/4" / 6.3 mm stereo phone jack
Maximum Output Level: 50 + 50 mW @ 33 Ohms load
Output Impedance: 10 Ohms
(Controllable by volume knob)
External Analog Audio Input Connector: 1/4" / 6.3 mm monaural phone jack
Maximum Input Level: -10 dBu
Input Impedance: 22 kOhms
MIDI In
USB Type B
CV In/Out Controls Keyboard CV (In/Out): 1 V/octave
Connector: 1/8" / 3.5 mm monaural phone jack
Gate Gate In: +3 V (minimum)
Gate Out: +10 V, key down; 0 V all keys up
Connector: 1/8" / 3.5 mm monaural phone jack
TRIG Connector Trig In: +3 V pulse min., 10 μsec duration minimum
Trig Out: +10 V pulse on key depression, 10 μsec duration
Connector: 1/8" / 3.5 mm monaural phone jack
Power Power Supply: AC adapter jack (9 VDC)
Power Consumption: 6.5 W
Dimensions (W x D x H) 19.5 x 10.4 x 3.5" / 496.1 x 264.9 x 88.9 mm
Weight 8.2 lb / 3.7 kg