Lectrosonics SMWB, TX; DIGITAL HYBRID WIDEBAND; SM SERIES; SINGLE BATTERY

Vendor: Lectrosonics
Descriptions Lectrosonics SMWB, TX; DIGITAL HYBRID WIDEBAND; SM SERIES; SINGLE BATTERY The Lectrosonics SMWB is a wireless beltpack transmitter that can also act as a recording device, capturing audio onto microSDHC cards. Paired with...
$1,499.00 $2,120.00
Title

Lectrosonics SMWB, TX; DIGITAL HYBRID WIDEBAND; SM SERIES; SINGLE BATTERY

The Lectrosonics SMWB is a wireless beltpack transmitter that can also act as a recording device, capturing audio onto microSDHC cards. Paired with a lavalier or dynamic microphone, the transmitter is suitable for ENG (Electronic News Gathering), EFP (Electronic Field Productions), interviews for broadcast TV, and more. The Lectrosonics SMWB can provides Digital Hybrid Wireless technology, combining 24-bit digital-audio processing with an analog FM radio link to give you the benefits of both worlds, such as fewer dropouts and audio artifacts while maintaining a robust range of operation. The Lectrosonics SMWB transmitter is housed in a machined aluminum case, lending the unit a rugged and dependable shell. Its water-resistant control panel adds to its usability. The Lectrosonics SMWB can operate in A1 range (470 to 537 MHz) and B1 range (537 to 607 MHz), the transmitter offers selectable outputs to bolster its operating range, specifically among 25, 40, and 100mW. At lower values, the transmitter’s battery life will last longer; at higher values, the operating range is increased, though at the expense of battery life. Lightweight at 2.7 oz, the transmitter boasts settings which make it compatible with dynamic microphones, electret lavaliers, and even line-level sources—so long as they can plug into the TA5M 5-pin input connector.

Input gain adjustment is possible in 1 dB increments for a total range of 44 dB. You’ll also note the low-pass filters, which can be switched to roll off at 30, 50, 70, 120, or 150 Hz to mitigate low-end disturbances. This input section also boasts servo-bias input circuitry proprietary to Lectrosonics, as well as an analog limiter controlled with DSP that, sitting ahead of the mic preamp itself, protects the audio path from overload. With its dual-release envelope, it maintains acoustic transparency, even though it can achieve over 30 dB of gain reduction. The Lectrosonics SMWB utilizes DSP that renders it suitable for use with all Lectrosonics Digital Hybrid receivers, though it is also backward compatible for use with 100 and 200 series transmitters, IFB receivers, and various analog receivers from third-party manufactures. The Lectrosonics SMWB unit is powered by one AA battery, making use of switching power supplies to offer consistent voltages to its internal circuitry throughout its battery life. One AA battery is included. Expanding the SMWB’s functionality is its built-in recording capability, for use when transmission is simply not possible due to the conditions of the environment. The recorder operates at 24-bit/44.1 kHz, recording .WAV files to microSDHC cards. As a transmitter, the Lectrosonics SMWB supplies an audio frequency range of 35 Hz to 20 kHz, though during recording, that lower value extends down to 20 Hz. You cannot use the transmitter and the recorder simultaneously, but it’s nice to have the option to select between the two. The Lectrosonics SMWB transmitter includes a flexible steel-cable antenna.

Lectrosonics SMWB Main Features

  • Ultra-lightweight, corrosion resistant housing
  • Water resistant seals for use in damp environments
  • LCD interface with lockout option
  • Programmable compatibility modes for use with a wide variety of different receivers
  • Servo Bias input circuitry
  • IR (infrared) port for fast setup
  • Covers 2 frequency blocks (export versions cover 3 frequency blocks)
  • Update firmware in the field via Micro SD card reader
  • Alternate use as a recorder on an internal microSDHC memory card
Transmitter
Operating Frequencies A1: 470 to 537 MHz / B1: B1: 537 to 607 MHz
Channel Spacing Selectable between 25 or 100 kHz
RF Power Output Switchable among 25, 50 and 100 mW
Compatibility Modes Digital Hybrid Wireless (NU Hbr), 200 Series, 100 Series, Mode 3, Mode 6, IFB
Pilot Tone 25 to 32 kHz; 5 kHz deviation (digital hybrid mode)
Frequency Stability ± 0.002%
Deviation ± 75 kHz maximum (digital hybrid mode)
Spurious Radiation Compliant with ETSI EN 300 422-1
Equivalent Input Noise -125 dBV, A-weighted
Input Level If set for dynamic mic: 0.5 to 50 mV before limiting, greater than 1 V with limiting
If set for a lavalier mic: 1.7 to 170 uA before limiting; greater than 5000 uA (5 mA) with limiting
If set for line-level input: 17 mV to 1.7 V before limiting; greater than 50 V with limiting
Input Impedance Dynamic mic: 300 Ohms
Lavalier: Input is virtual ground with servo adjusted constant current bias
Line level: 2.7 kOhms
Input Level Soft limiter, 30 dB range
Bias Voltage Fixed 5 V at up to 5 mA; selectable servo bias for any electret lavalier (2 or 4 V)
Gain Control Range 44 dB; panel mounted membrane switches
Modulation Indicators Dual bicolor LEDs indicate modulation; -20, -10, 0, +10 dB referenced to full modulation
Controls Control panel with LCD and 4 membrane switches
Low Frequency Roll-Off Adjustable from 35 to 150 Hz
Audio Frequency Response 35 Hz to 20 kHz, ±1 dB
Signal to Noise Ratio Off: 103.5 dB (no limiting); 108.0 dB (with limiting)
Normal: 107.0 dB (no limiting); 111.5 dB (with limiting)
Full: 108.5 dB (no limiting); 113.0 dB (with limiting)
THD 0.2% typical (400 Series mode)
Audio Input Jack Switchcraft 5-pin locking (TA5F)
Recorder
Storage Media microSDHC memory card
File Format .WAV files (BWF)
A/D Converter 24-bit
Sampling Rate 44.1 kHz
Recording Modes HD mono mode
24-bit: 144 kbps 32-bit: 192 kbps

Split gain mode
24-bit: 288 kbps
32-bit: 384 kbps
Input Analog mic/line level compatible; servo bias preamp for lavalier microphones (2 and 4 V)
Input Level Dynamic mic: 0.5 to 50 mV
Electret mic: Nominal, 2 to 300 mV
Line level: 17 mV to 1.7 V
Input Connector TA5M 5-pin male
Audio Performance Frequency response: 20 Hz to 20 kHz; +0.5/-1.5 dB
Dynamic range: 110 dB (A-weighted), before limiting
Distortion: < 0.035%
Operating Temperature Range -5 to 122°F / -20 to 50°C
General
Antenna Flexible, unbreakable steel cable
Battery AA lithium, disposable
Battery Life (approx.) 50 mW (1 x AA): 7.3 hours
100 mW (1 x AA): 5.5 hours
Dimensions 2.3 x 1.8 x 0.6" / 58 x 46 x 16 mm (without microphone)
Weight 2.7 oz / 75.9 g (with batteries)