Listen Technologies MH-5200-072 Meeting House Receiver

Vendor: Listen Technologies
Listen Technologies MH-5200-072 Meeting House Receiver The Listen Technologies' MH-5200-072 Meeting House Receiver is an LR-5200-072 with customized programming that incorporates Listen Technologies’ advanced new generation of personal listening products, iDSP or Intelligent...
$261.00 $289.00
Title

Listen Technologies MH-5200-072 Meeting House Receiver

The Listen Technologies' MH-5200-072 Meeting House Receiver is an LR-5200-072 with customized programming that incorporates Listen Technologies’ advanced new generation of personal listening products, iDSP or Intelligent Digital Signal Processing. Users of Listen enjoy crystal clear audio that is appealing to all users, hearing-impaired or not, thanks to the company's exclusive DSP audio processing technology. The amount of batteries in landfills is decreased while ownership expenses and hassles are drastically reduced thanks to advanced green battery technology. The item comes with a field-replaceable lithium-ion battery. The integrated neck loop / lanyard with DSP loop driver, improves the listening experience for T-coil users. iDSP is the smallest device of its kind, making it easier to wear and easier for venues to dispense, store and maintain.

The OLED display of the MH-5200-072 may be used to set up channel names, check battery life, channel status, and charge activation. An active channel can be cycled through, sought to, or locked to using a programmable channel choose button. Connect the iDSP neck loop/lanyard or ear phones via two 3.5 mm output jacks (ear phones could be shared). The Micro USB connection is used for charging and with the iDSP software suite for programming changes, inventory management and firmware updates. The result is an exceptional listening experience in your meeting house chapel.

Audio

Frequency Response 50 Hz - 15 kHz (±3 dB)
System Distortion < 2% total harmonic distortion (THD) at 80% deviation
Output/s Two (2) 3.5 mm (0.14 in.) connectors, unbalanced, 0 dBu nominal output level, 16 mW maximum, impedance 32 ohm
System Signal to Noise Ratio SQ enabled 80 dB, SQ disabled 60 dB

Controls

User Controls Power, up/down volume, Listen button for end user channel selection
Programming Via software and USB port
Set-up Controls Press and hold up/down volume buttons for 5 seconds to enter channel adjust, use up/down to select channel

Indicators

LEDs Flashes when batteries are low or to indicate charging, solid when fully charged
Display Channel designation,battery level, unit number, charging status

RF

Frequency Range 72.025 - 75.950 MHz
Number of Channels 17 wide band, 40 narrow band
Sensitivity .6uV typical, 1 uV maximum for 12 dB sinad
Frequency Accuracy ± .005% stability 32 to 122 ºF (0 to 50 ºC)
Squelch Programmable in 20 steps, automatic on loss of RF signal
Antenna Type Uses ear phone/neck loop lanyard and short ear phone cable or standard earphone cable

Power

Power Supply Micro USB connector, 5 V, 500 mA
Battery Type Lithium Ion 3.7 Vdc, 1200 mAh
Battery Life 8 Hours of continuous use
Battery Charging Time Fully charged in 2.5 Hours

Physical

Color Black
Unit Weight with Batteries 2.40 oz. (68 g)
Shipping Weight 3.20 oz. (91 g) with 1.0 lbs. (454 g) minimum
Dimensions (H x W x D) 3.75 x 2.0 x 0.64 in. (9.6 x 5.0 x 1.7 cm)
Unit Weight 1.60 oz. (45 g)
Dimensions with Belt Clip 3.75 x 2.0 x 0.80 in. (9.6 x 5.0 x 2.1 cm)