Shure MX184 Supercardioid Condenser Lavalier Microphone with 4’ (1.2m) attached cable, Belt-Clip Preamp with XLR, Rotable Tie Clip, Dual Tie Clip, Snap-Fit Windscreen
Vendor: Shure
Available
Shure MX184 Supercardioid Condenser Lavalier Microphone with 4’ (1.2m) attached cable, Belt-Clip Preamp with XLR, Rotatable Tie Clip, Dual Tie Clip, Snap-Fit Windscreen
The Shure MX184 Supercardioid Wired Lavalier Microphone is appropriate for conferencing, presentations, and for other similar applications. The Shure’s MX184 is featuring a condenser capsule with a broad dynamic range and is tailored with full-range frequency response. The microphone is also featured with an interchangeable cartridge system for different applications and comes with a rotatable tie clip that can pivot in 90-degree increments for improved placement options. The balanced and transformerless output increases the immunity to noise over long cable runs, and the supplied dual tie clip can hold two microphones for dual miking applications. A supplied snap-fit foam windscreen helps control breath noises.
- Condenser lavalier microphone
- Interchangeable cartridges for omni-directional, cardioid, and super-cardioid polar patterns
- Includes pivoting, single-microphone tie clip, and dual microphone tie clip
- Black snap-fit foam windscreen
- Compatible with all Shure wireless transmitters
- Attached 4 ft cable with Tini Q-G connector
- Transducer: Electret Bias Condenser
- Polar Pattern: Supercardioid
- Frequency Response: 50 Hz to 17 kHz
- Dynamic Range (Typical): 94 dB (@ 1 kHz, A-Weighted)
- Signal-to-Noise Ratio: 66 dB
- Maximum Input Sound Level: 122 dB (@ 1 kHz, 1% THD)
- Power Requirements: 11 - 52v DC (with Belt Clip Preamp)
- Output Impedance: 150 ohms (180 Ohms Actual)
- Output Connectors: XLR-3M Type
- Pad: None
- Low-Frequency Roll-Off: None
- Applications: Radio, Videography, Television, and Broadcast.
-
Dimensions: Microphone Housing: .85 x .46" (22 x 12mm) LxW
In-Line Pre-Amp: 3.89 x .79" (99 x 20mm) LxDiameter
Cable: 4' (1.2m) Long (w/TA4F Connector) - Weight: .12 oz. (3.4 g)