Lectrosonics DPR, Digital Plug-on Transmitter

Lectrosonics DPR, Digital Plug-on Transmitter

The Lectrosonics DPR is a unique plug-on transmitter design to perfectly match in any microphone or line level source via a standard XLR connector. The Lectrosonics DPR can tune in 100 kHz or 25 kHz steps across the UHF television band from 470.100 to 607.950 MHz, with a selectable output power of 25 or 50 mW. The Lectrosonics DPR is a purely digital architecture  utilizes AES-256-CTR encryption for high level security applications. The Lectrosonics DPR transmitter is specially designed with high efficiency digital circuitry for extended operating time on two AA batteries, with status indicated by a multi-color LED. An IR (infrared) port is included to simplify setup with IR enabled receivers. Updates can be made via SD card. Also, the Lectrosonics DPR input amplifier uses an ultra low noise op-amp for quiet operation. It is gain controlled with a wide range, dual envelope limiter, providing over 30 dB of headroom above full modulation. A 24-bit A-D converter digitizes the audio, then filters out supersonic noise above 21 kHz.

Lectrosonics DPR Main Features

• Wideband UHF tuning range – 470-608 MHz (470-614 MHz for E01 version)
• Accepts microphone or line level signals
• Selectable 5, 15, 48 volt phantom power
• Selectable 25/50 mW RF output power
• Adjustable low frequency roll-off
• Powered by two AA batteries
• IR (infrared) port for fast setup
• Remote controlled “dweedle” tones (audio tone set-up control)
• Time code jam sync with
• Solid machined aluminum housing
• On board recording
• Encryption 256 Bit AES, CTR Mode