Pro Intercom BLAZON180 Signal Light Front-mounted rectangular strobe with 180° visibility.

Pro Intercom BLAZON180 Signal Light Front-mounted rectangular strobe with 180° visibility

Strobe Light Designed to Limit Visibility to 180 Degrees

The Pro Intercom BLAZON180 is a signal light that is integrating a front mounted rectangular xenon lamp for limiting the visibility of the flashes to 180 degrees.

Pro Intercom BLAZON180 is triggered by the same voltage which is lighting also the normal signal lamps in the intercom system. Any the time that any signal lamp button on any station in the same circuit is pressed, the Pro Intercom BLAZON180 will be activated. The xenon lamp is permanently connected. Circuitry is provided for sustaining the Blazon 180 for 4 seconds after being triggered. The xenon lamp has a flash rate of 2Hz, that provides 8 flashes per cycle.

The Pro Intercom BLAZON180 is connected to the headset intercom system in the same manner as a belt pack. Pro Intercom BLAZON180 has two 3-pin XLR connectors on the rear panel. By convention (to differentiate from microphone inputs) the female connector is designated as input. The male connector is provided for looping onwards to the next station in the system. Reversing these connections will not affect operation.

Pro Intercom BLAZON180 is powered by the intercom power supply and requires no batteries or other external power source. In its ready mode it draws only 21.1mA; with the strobe active, 120mA. When calculating power supply requirements, you may consider the Blazon 180 as the approximate equivalent of 3 or 4 belt packs.

• Xenon lamp with a flash rate of 2Hz, providing 8 flashes per cycle
• Two 3-Pin XLR connectors on the rear panel
• Ribbed, extruded aluminum case and glass-filled nylon end bezels
• Powered by the intercom power supply and requires no batteries or other external power source