ATI Audio ADA 206-XLR Dual 1x3 Low Noise Analog Distribution Amplifier - XLR Connectors

ATI Audio ADA 206-XLR Dual 1x3 Low Noise Analog Distribution Amplifier - XLR Connectors

The ATI ADA 206-XLR is perfect for each application and suitable for every budget. It helps in avoiding RF and hum pick-up problems from noisy and lossy splitters.  Also, it removes roll-offs and distortion from mismatched load impedances and enjoy the maximum versatility that this unit provides. Prevent hard-to-find shorts from multiple taps on critical lines and helps in boosting console outputs. 

Features:

• Six balanced outputs divided among two independent 1 in to 3 out channels; an internal jumper plug parallels inputs for 1x6 operation
• Xlr input and output connectors
• Master input level controls plus plug programmable input gain accepts nominal inputs of -20, -10 or +4dbu; individual audio taper output controls adjust outputs from +8 to -10dbm
• Ground sensing active balanced outputs drive balanced or grounded loads with extremely low distortion and low noise

Low Noise Analog Distribution Amplifier Specs

• Gain: 40dB Max
• Nominal Levels: +4dBm out , +4 to-20dBu in.
• Peak Levels: +22dBu in., +22dBm out.
• Distortion THD: .10% at peak levels; .005 at nominal levels; 20Hz to 20kHz
• IMD: .05% maximum
• SMPTE Response: +/-.25dB 20 to 20,000 Hz
• Crosstalk & Output Isolation: 70dB min at 10kHz, a shorted output does not affect any other outputs.
• Noise: 20kHz bandwidth, -75dBm out at full gain.
• Inputs: 20k ohm active balanced, split and RF bypassed, 60dB
• CMR: at 60Hz