Audix ADX10FL, MIC,MINI INST,W/CLIP FOR FLUTE

Audix ADX10FL, MIC,MINI INST,W/CLIP FOR FLUTE,  3' CBL, May be used wired or with RAD360 Wireless System

The Audix ADX10FL is known with a uniformly controlled cardioid polar pattern, helping to isolate the area or section being miked from other instruments or vocals on stage. The Audix ADX10FL also features with smooth and accurate frequency range of 50 Hz - 18 kHz, the Audix ADX10FL is built with a lightweight, low profile and will provide natural sound with exceptional transient response.

Audix ADX10FL is a cardioid condenser microphone that works with the Audix wireless systems specifically for use with a flute, it includes a clip that attaches to the headstock of a flute, an 8' cable terminating to a miniXLRf connector.

Audix ADX10FL manufactured to high standards and tight tolerances, the ADX10FL miniatrized condenser flute microphone features a modular threaded capsule, machined brass body with matte black finish, high quality shielded microphone cable and a variety of optional accessories.

Audix ADX10FL Features

• Miniature condenser flute microphone
• Natural, accurate sound reproduction
• May be used wired or with RAD360 Wireless System
• Designed, assembled & tested in the USA
• 3 year warranty

Transducer Type : Pre-Polarized Condenser
Frequency Response : 50 Hz - 18 kHz
Polar Pattern : Cardioid
Output Impedance : 250 ohms
Sensitivity : 4.5 mV / Pa @ 1k
Equivalent Noise Level : <29 dB (A-weighted)
Signal to Noise Ratio : >65 dB
Maximum SPL : ≥120 dB
Power Requirements : 5-52 V phantom
Connector Shielded : 3’ terminating to a
minature 3 pin XLRf
Polarity : Positive pressure on diaphragm
produces positive voltage on pin
2 relative to pin 3
Materials / Finish : Machined Brass Capsule / Black
Finish
Weight : 110 g / 4 oz
Length : 25 mm / 0.98 in