-
Spectral Controls on MUSIC input
- Weight Bass filter (shelving) ±12dB gain from around 80Hz@6dB/8ve
- Edge Treble filter (shelving) ±12dB gain from around 8kHz@6dB/8ve
- Switch Pressed in this activates Spectral Controls
-
Inputs
- Connectors ¼ jack, three pole, Tip /in phase, Ring cold/reverse phase ,sleeve 0V
- Levels Optimum results occur with input levels of +2dBu to +12dBu, maximum input level > +12dBu
- Freq Response Music inputs <20Hz to >35 kHz, modulator input DC to >35kHz
- Input Impedance >10k
- MOD Module8ion Input - this feeds one side of Ring Mod
- MUSIC Main Input - this feeds the other side of Ring Modulator if spectral controls are activated they vary the spectrum of this input.
- Breakthrough MOD in +10dBm with no MUSIC signal, MOD out <-65dBm maximum, typically <-70dBm, same for MUSIC signal with no MOD.
-
Outputs
- Connectors ¼ jack, three pole, as above
- OSC Oscillator output at ca +12dBu
- Levels For input levels of +4dBu to +12dBu output will be around +4dBu - +12dBu, maximum output level around 65kHz
- Freq Response Flat from DC to a -3dB point at around 65kHz
- Signal to noise -82dB (equivalent to a good mic set to medium gain)
-
OSC
- Fine Varies around centre frequency by ca 5%
- Tune Varies centre frequency over selected range
- Range Selects from 4 ranges - [0.2Hz-9Hz, 2Hz-90Hz, 20Hz-900Hz and 380Hz-11kHz]
- CV Inputs CV Inputs to each oscillator on ¼ jacks (unbalanced), 0-15V, V/Hz characteristics
- OSC Outs Output for both oscillators @ +12dBu
DACS FREQue II MK2 Ring Modulator Includes
- FREQue II MK2 Ring Modulator
- IEC Power Cable
- Manual
DACS FREQue II MK2 Ring Modulator Downloads