Shure GLXD14/93 Wireless Lavalier System with GLXD4 Wireless Receiver, GLXD1 Bodypack Transmitter and WL93 Lavalier Microphone (SB902 Battery included)

Vendor: Shure
Shure GLXD14/93 Lavalier System with GLXD4 Wireless Receiver, GLXD1 Bodypack Transmitter and WL93 Lavalier Microphone (SB902 Battery included)GLXD1 bodypack transmitter is included in the GLXD14/WL93 Lavalier Wireless System from Shure. Also, it includes a GLXD4...
$519.00 $649.00
Title

Shure GLXD14/93 Lavalier System with GLXD4 Wireless Receiver, GLXD1 Bodypack Transmitter and WL93 Lavalier Microphone (SB902 Battery included)

GLXD1 bodypack transmitter is included in the GLXD14/WL93 Lavalier Wireless System from Shure. Also, it includes a GLXD4 receiver and a WL93 omnidirectional subminiature lavalier microphone. The system is operated on the 2.4GHz ISM band in the Z2 frequency band between 2400 & 2483.5MHz. Shure's LINKFREQ automatic frequency management is featured in both the GLXD1 transmitter and the GLXD4 receiver. It permits them to scan for the clearest frequency available & allows to link automatically with each other without any requirement of setup from you besides turning both the units on.  


With their continuous interference monitoring, both the transmitter and receiver automatically switch to the clearest frequencies available to avoid interference and dropouts. The GLXD1 includes a rechargeable battery pack that provides up to 16 hours of operation of a full charge. The system has a 200' range of operation and can be used with 7 other GLX-D systems simultaneously. 

The WL93 lavalier mic has an omnidirectional polar pattern and comes with a mounting block attached to a tie bar as well as a sew-on mounting bracket.

GLXD4 Digital Wireless Receiver (Z2 Band: 2400 - 2483.5 MHz)

The GLXD4 Digital Wireless Receiver from Shure is designed to work with Shure's GLX-D series digital wireless systems. It operates on Shure's Z2 frequency band between 2400 and 2483.5 MHz on a 2.4 GHz ISM wireless band. Shure's proprietary LINKFREQ automatic frequency management, which scans for clearest available frequency range, will automatically link the GLXD4 and a compatible transmitter. The GLXD4 has continuous interference monitoring and will automatically switch frequencies to avoid interference and drop outs. The integrated battery charging station allows you to charge your transmitter when not in use, or a back-up battery pack while in use. Your transmitters remaining battery life is displayed on the GLXD4's front-panel LCD screen. Up to 8 systems can be used simultaneously.

GLXD1 Bodypack Transmitter (Z2 Band: 2400 - 2483.5 MHz)

The GLXD1 Bodypack Transmitter from Shure is designed to work with Shure's GLX-D series digital wireless systems. It operates on Shure's Z2 frequency band between 2400 and 2483.5 MHz on a 2.4 GHz ISM wireless band. The transmitter provides up to a 200' range of operation and features Shure's LINKFREQ automatic frequency management that allows it to automatically link to a GLX-D compatible transmitter without having to perform any setup. It includes a rechargeable battery pack that provides up to 16 hours of performance time per charge. The battery can be recharged with the included USB charger cable. A 15-minute charge can provide up to 1.5 hours of performance time. The GLXD1 has a 4-pin TA4M connector and is compatible with both lavalier microphones as well as instrument cables with a proper adapter.

 

WL93 Professional Micro-Lavalier Omni Mic (Black)

The Shure model WL93 Microphones are economical omnidirectional, subminiature, lavalier, condenser microphones designed for general speech applications where a visually unobtrusive microphone is desirable. All WL93 models are supplied with a mounting block with attached tie bar, a sew-on mounting bracket, and an acoustic windscreen to minimize wind noise in outdoor applications. All WL93 models include a cable terminated with a 4-pin mini connector which connects directly to a Shure wireless body-pack transmitter.

  • Subminiature lavalier design; ideal size for theater, television broadcasting, video, film, and sound reinforcement
  • Uniform omnidirectional polar pattern
  • Full, clear sound comparable to larger microphones
  • Smooth extended frequency response with presence rise specially tailored for chest-worn microphone operation
  • Controlled low-frequency rolloff reduces low-frequency clothing and room noise
  • Low distortion, wide dynamic range
  • Small, inconspicuous mounting hardware


  • Outputs: 1x XLR Output
  • 1x 1/4" (6.35 mm) Output
  • Output Impedance : XLR: 100 Ω
    1/4": 100 Ω, 50 Ω unbalanced
  • Maximum Audio Output Level Analog: XLR: 1 dBV (into 600 Ω load)
    1/4": 8.5 dBV (into 3 kΩ load)
  • Tuning Frequency Range: 2400 to 2483.5 MHz
  • Range of Operation: 200' (60 m) (typical, depends on RF signal absorption, reflection, and interference)
  • Transmit Mode: Frequency Hopping
  • Frequency Response: 20 Hz to 20 kHz
  • Dynamic Range: 120 dB, A-weighted
  • RF Sensitivity: -88 dBm, typical
  • Total Harmonic Distortion: 0.2%, typical
  • RF Output: 10 mW E.I.R.P., maximum
  • Operating Temperature Range: 0° to 135°F (-18° to 57°C)
  • Storage Temperature Range: -20° to 165°F (-29° to 74°C)
  • Pin Configuration: XLR: 1= ground, 2= hot, 3=cold
    1/4": Tip= audio, ring= no audio, sleeve= ground
  • Antenna: Impedance: 50 Ω
    Type: 1/2 wave sleeve dipole, non-removable
    Max Input Level: -20 dBm
  • Power Requirements: 14 to 18 V DC (tip positive with respect to ring), 550 mA
  • Spurious Rejection: >35 dB, typical
  • Gain Adjustment Range: -20 to 40 dB in 1 dB steps
  • Phantom Power Protection: Yes
  • Housing: Molded plastic
  • Dimensions (HxWxD) : 1.6 x 7.2 x 4.6" (40 x 183 x 117 mm)
  • Weight: 10.1 oz (286 g)
  • Packaging Info
  • Box Dimensions (LxWxH): 2.315 x 18.25 x 13.0"
  • GLXD1 Bodypack Transmitter (Z2 Band: 2400 - 2483.5 MHz)
  • Connector: 1x unbalanced 4-pin TA4M male mini-connector
  • Tuning Frequency Range: 2400 to 2483.5 MHz
  • Range of Operation: 200' (60 m) (typical, depends on RF signal absorption, reflection, and interference)
  • Transmit Mode: Frequency Hopping
  • Frequency Response: 20 Hz to 20 kHz
  • Dynamic Range: 120 dB, A-weighted
  • RF Sensitivity: -88 dBm, typical
  • Total Harmonic Distortion: 0.2%, typical
  • RF Output: 10 mW E.I.R.P, maximum
  • Operating Temperature Range: 0° to 135°F (-18° to 57°C)
  • Storage Temperature Range: -20° to 165°F (-29° to 74°C)
  • Polarity: Positive pressure on microphone diaphragm (or positive voltage applied to tip of WA302 phone plug) produces positive voltage on pin 2 (with respect to pin 3 of low-impedance output) and the tip of the high impedance 1/4-inch output
  • Battery Life: Up to 16 hours
  • Power Requirements: 3.7 V Rechargeable Li-Ion
  • Input Impedance: 900 kΩ
  • RF Output: 10 mW E.I.R.P. maximum
  • Maximum Input Level: 1 kHz at 1% THD
    8.4 dBV (7.5 Vp-p)
  • Antenna: Internal Monopole
  • Pin Configuration:
    1: ground (cable shield)
    2: +5 V bias
    3: Audio
    4: Tied through active load to ground (On instrument adapter cable, pin 4 floats)
  • Housing: Cast Metal
Dimensions (H x W x D): 3.56 x 2.54 x 0.90" (90.4 x 64.5 x 22.9 mm), without antenna

Packaging Info

 

Box Dimensions (LxWxH): 11.024 x 5.433 x 3.228"

WL93 Professional Micro-Lavalier Omni Mic (Black)

  • Transducer: Electret Condenser
  • Polar Pattern: Omnidirectional
  • Frequency Response: 80 Hz - 20 kHz
  • Dynamic Range (Typical): 98dB @ Max. SPL, A-Weighted
  • Signal-to-Noise Ratio: 72dB
  • Maximum Input Sound Level: 120dB @ 1 kHz,(1% THD)
  • Power Requirements: 2 to 10v; 5v Nominal (Pin 2 to Pins 3 and 4) (Supplied by Shure Wireless Body Transmitter Pack)
  • Output Impedance: 3000 Ω
  • Output Connectors: TA4F, for Use with the Shure Wireless Transmitters
  • Case: Zippered Carrying Pouch
  • Pad: None
  • Low Frequency Roll-Off: None
  • Applications: Radio, Television and Broadcast, Wireless Videography.
  • Dimensions: Approximately: .023 x 0.37" (5.84 x 9.40mm DiameterxL
  • Weight: Approximately: 0.57 oz. (16 g)
  • Packaging Info
  • Box Dimensions (LxWxH): 6.7 x 4.3 x 3.4"