Sonifex RB-MA1 Single Microphone Amplifer
Vendor: Sonifex
Available
Sonifex RB-MA1 Single Microphone Amplifer
To drive lengthy lines from microphones to mix equipment or to convert mic-level signals to line level, the RB-MA1 is composed of a low-noise microphone pre-amplifier. On the back panel are the controls and connections. The microphone input is electronically balanced and of the XLR-3 variety. Both dynamic and powered microphones can be used by adjusting the gain of the input via a recessed pre-set potentiometer. The line output is electronically balanced and of the XLR-3 type. You can supply both balanced and unbalanced equipment by wiring it unbalanced by grounding the non-phase signal. A switch is present to operate a high pass filter, which has a low frequency roll-off at 125Hz, and to supply the attached microphone with phantom power at +48V.
Audio Specification |
|
Maximum Input Level: | -10dBu |
Maximum Output Level: | +28dBu |
Low Frequency Roll-Off: | 125Hz @ 6dB/octave |
E.I.N.: | 130dB |
Common Mode Rejection: | >60dB typically |
Frequency Response: | 20Hz to 20kHz ±0.1dB (600Ω load, ref 1kHz) |
Input Impedance: | 2kΩ nominal balanced |
Output Impedance: | <50Ω |
Gain Range: | Adjustable 36dB to 75dB gain |
Distortion: | 0.01% THD @ 1kHz, ref +8dBu output |
Phantom Power: | 48V |
Connections |
|
Input: | 1 x XLR 3 pin female (Balanced) |
Output: | 1 x XLR 3 pin male (Balanced, can be unbalanced) |
Mains Input: | Filtered IEC, switchable 110-120V, or 220-240V, fused, 6W max |
Fuse Rating: | Anti-surge fuse 100mA 20 x 5mm (230VAC) Anti-surge fuse 250mA 20 x 5mm (115VAC) |
Equipment Type |
|
RB-MA1: | Single microphone amplifier |
Physical Specification |
|
Dimensions (Raw): | 28cm (W) x 10.8cm (D) x 4.2cm (H) (1U) 11” (W) x 4.3” (D) x 1.7” (H) (1U) |
Dimensions (Boxed): | 36cm (W) x 20.5cm (D) x 6cm (H) 14.2” (W) x 8” (D) x 2.4” (H) |
Weight: | Nett: 0.90kg Gross: 1.35kg Nett: 2lbs Gross: 3lbs |