Sonifex RB-VHDMA8 3G/HD/SD-SDI De-embedder 8 Channel Analogue Outputs
Vendor: Sonifex
Available
Sonifex RB-VHDMA8 3G/HD/SD-SDI De-embedder 8 Channel Analogue Outputs
The RB-VHDMA8 is a 19-inch rack unit that houses an 8 channel analog de-embedder. Up to eight channels from any audio group of an SDI video stream can be selectively de-embedded by the machine and sent to any analogue output. The video then splits into two separate routes, each of which can have its audio groups added, removed, or passed through before being routed to the re-clocked SDI outputs. The buttons and lights on the front panel are used to regulate the de-embedding channel routing. Indicators for the presence of audio groups and the status of SDI inputs are similarly LED-based. The Sonifex SCi software can be used to remotely control the machine over Ethernet or serial port connections. It has a triple rate SDI receiver with automatic input rate detection and equalisation along with two re-clocked and individually buffered SDI outputs. It supports the full range of single link 3G, HD and SD standards from NTSC and PAL up to 1080p 60Hz. There is independent level control for each analogue output channel, which can be adjusted from -24dB through to +24dB in 0.5dB steps. Jumpers within the machine can be used to adjust the three full-scale gain settings available for the analogue outputs. Reference FSD of +12dBu, +18dBu, and +24dBu are acceptable settings. One type of output can be employed for each of the paralleled balanced and unbalanced output connections.
Front Panel Controls & Indicators |
|
De-embed Bank Select: | Bank 1 or 2 |
Bank Channel Select: | Channels 1, 2, 3 or 4 |
Group Select: | Groups 1, 2, 3 or 4 |
Group Channel Select: | Group channels 1,2,3 or 4 |
Status: | 1 x SDI input status LED 2 x SDI output LEDs 4 x Audio group status LEDs |
Audio Specifications |
|
Max Output Level: | +24dBu (balanced) |
Output Impedance: | <50Ω (balanced) |
Gain Range: | 12dBu, 18dBu or 24dBu ref FSD (jumper selectable) |
Signal to Noise: | Better than -106dB (RMS A-weighted at 24-bit, balanced) |
Distortion and Noise: | Better than -85dB THD+N at 1kHz (balanced) |
De-embed Delay: | 3G/HD/SD: 1.1 ms |
Connections |
|
Analogue Audio Outputs: | 8 output channels via BNC (unbalanced) or D-type socket (balanced) |
Analogue Audio Connectors: | 8 x BNC 2 x 25-way D-type |
Power Supply: | Universal filtered IEC, continuously rated 85-264VAC @47-63Hz, fused, max 14W |
Equipment Type |
|
RB-VHDMA8 | 3G/HD/SD-SDI De-embedder, 8 channel analogue outputs |
Common Specifications For RB-VHEMA8, RB-VHDMA8, |
|
SDI Specification |
|
SDI Input: | 1 x BNC, 3G/HD/SD-SDI |
SDI Outputs: | 2 x BNC, 3G/HD/SD-SDI, Re-clocked |
Impedance: | 75Ω |
Output Alignment Jitter: | <0.2UI (3G <0.3UI) |
Output Level: | 800mV +/- 10% |
Return Loss: | <15dB at 1500MHz |
SDI Supported Standards: | 270Mbps, SMPTE-259M-C (SD) 1.485 or 1.4835Gbps, SMPTE-292M (HD) 2.97 or 2.967Gbps, SMPTE-424M (3G), SMPTE 425M-A |
Supported Video Formats: | 525/59.94 (SMPTE-125M 625/50 (ITU-R BT.656) 720p/23.98, 24, 25, 29.97, 30, 50, 59.94, 60 (SMPTE-296M) 1035i/59.94, 60 (SMPTE-260M) 1080i/50, 59.94, 60 (SMPTE-274M) 1080p/23.98, 24, 25, 50, 59.94, 60 (SMPTE-274M) 1080pSF/23.98, 24, 25, 29.97, 30 (RP-211) 1080i/50 (SMPTE-295M)1080p/50 (SMPTE-295M) |
Video Delay: | SD: 290 pixels / 22 us HD: 570 pixels / 8 us 3G: 570 pixels / 4 us |
Embedded Audio: | 48kHz, synchronous SMPTE-272M-ABC SMPTE-299M |
Serial Port: | RS232, 9 way D-type |
Ethernet Port: | 10/100Mbps |
Fuse Rating: | Anti-surge fuse 2A 20 x 5mm |
Physical Specifications |
|
Dimensions (Raw): | 48cm (W) x 15.8cm (D*) x 4.2cm (H) (1U) 19” (W) x 6.2” (D*) x 1.7” (H) (1U) |
Dimensions (Boxed): | 59cm (W) x 27.5cm (D) x 11cm (H) 23.2” (W) x 10.8” (D) x 4.3” (H) |
Weight: | Nett: 1.8kg Gross: 2.3kg Nett: 4.0lb Gross: 5.1lb |
* Note that this product is deeper than standard Redboxes |